This specification establishes the requirements for the manufacture, testing, and acceptance of the BRU-32A bomb rack capable of carrying, releasing, and ejecting stores having suspension lugs spaced 14 inches and 30 inches apart. The BRU-32A bomb rack shall be utilized for carrying and forced ejection release of stores weighing from 500 pounds to 2,600 pounds. The test units in this specification define minimum acceptable requirements. Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Commanding officer, Naval Air Engineering Center, Systems Engineering and Standardization Department (SESD) Code 93, Lakehurst, NJ 08733-5100, by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. Intended Use: The bomb rack covered by this specification is a single carriage ejector bomb rack for carriage of 14-inch and 30-inch suspension stores, multiple carriage bomb racks, and external fuel tanks. The bomb rack is mounted externally in an aircraft wing pylon or fuselage and will accommodate stores ranging in diameter from 10 inches to 28 inches and weighing up to 2,600 pounds. The bomb rack is intended to be used on the F/A-18/TF-18 aircraft.

This specification establishes the requirements for the manufacture, testing, and acceptance of the BRU-32A bomb rack capable of carrying, releasing, and ejecting stores having suspension lugs spaced 14 inches and 30 inches apart. The BRU-32A bomb rack shall be utilized for carrying and forced ejection release of stores weighing from 500 pounds to 2,600 pounds. The test units in this specification define minimum acceptable requirements. Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Commanding officer, Naval Air Engineering Center, Systems Engineering and Standardization Department (SESD) Code 93, Lakehurst, NJ 08733-5100, by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. Intended Use: The bomb rack covered by this specification is a single carriage ejector bomb rack for carriage of 14-inch and 30-inch suspension stores, multiple carriage bomb racks, and external fuel tanks. The bomb rack is mounted externally in an aircraft wing pylon or fuselage and will accommodate stores ranging in diameter from 10 inches to 28 inches and weighing up to 2,600 pounds. The bomb rack is intended to be used on the F/A-18/TF-18 aircraft.